BMDBF - 907 RED OXIDE RUST INHIB PRIMR

  • MSDS: BMDBF
  • Manufacturer: EVR GARD COATINGS CO
  • Product Name: 907 RED OXIDE RUST INHIB PRIMR
  • National Stock Number: 8010-00N026710
Product Identification

Product ID:907 RED OXIDE RUST INHIB PRIMR
MSDS Date:09/15/1987
FSC:8010
NIIN:00N026710
MSDS Number: BMDBF

Responsible Party
EVR-GARD COATINGS CO
16400 GARFIELD AVE
PARAMOUNT, CA 90723
US

Emergency Phone: 213-531-0131

Info Phone: 213-531-0131

Preparer: BORNEO

Cage: 5G582

Contractor
EVR-GARD COATINGS CO
PARAMOUNT, CA 90723 US

Telephone: 310-531-0131

Cage: 5G582

Ingredients

5 @ 68F.

CAS: 64742-86-5

RTECS: LX3296500

Fraction By Weight: 62.12%

OSHA PEL 125 PPM (MFR)

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL:EXCESSIVE INHAL OF VAPS MAY RSLT
IN DIZZ & HDCH. UNCON IN EXTREME CASES. EYE:IRRITANT.
SKIN:IRRITANT. AFFECTED AREA WILL SHOW SIGNS OF REDNESS & RASH IF
NOT WASHED WITH SOAPY WATER IMMED. INGEST :IRRIT OF RESP TRACT
CHARACTERIZED BY HDCH, DIZZ, STAGGERING, CONFUSN & UNCON & COMA IN
EXTREME CASES. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:ACUTE/CHRONIC:INHAL:IRRITATION OF NOSE, THROAT
& EYES, DIZZINESS, WEAKNESS, FATIGUE, NAUSEA, HEADACHE. SYMPTOMS
DISAPPEAR WHEN EXPOSURE CEASES. EYE/SKIN:MAY CAUSE IRRITATION.
CHRONIC:REPORTS HAVE ASSO CIATED REPEATED AND PROLONGED
OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN AND
NERVOUS SYSTEM DAMAGE.
Medical Cond Aggravated by Exposure:PROLONGED OR REPEATED CONTACT MAY
CAUSE DERMATITIS.

First Aid

First Aid:INHAL:MOVE TO FRESH AIR. EYE:FLUSH WITH PLENTY OF WATER FOR
AT LEAST 15 MINUTES. SKIN:REMOVE SOAKED/CONTAMINATED CLOTHING AND
WASH SKIN WITH SOAPY WATER THOROUGHLY. APPLY LOTION OR OIL TO
AFFECTED ARE A AFTER THOROUGH WASHING. INGEST:DO NOTINDUCE
VOMITING. CALL MD IMMEDIATELY.

Fire Fighting

Lower Limits:1%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. FIGHT AS LIQ VOLAT FIRE. CLSD CNTNRS MAY EXPLO WHEN EXPOSED TO
EXTERME HEAT-KEEP AWAY FROM (SUPP DATA)
Unusual Fire/Explosion Hazard:AVOID APPLIC IN AREAS OF PILOT LIGHTS,
SPARKS OR OTHER IGNIT SOURCES AS VAPS MAY ACCUMULATE ON FLOOR &
IGNITE. KEEP CNTNRS CLSD TIGHTLY & STORE IN COOL (SUPDAT)

Accidental Release

Spill Release Procedures:ABSORB SPILLED MATERIAL WITH ABSORBENTS, SUCH
AS SAWDUST, CLAYS, ETC. FLUSH SPILL AREA WITH LOTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DO NOT STORE NEAR OPEN FLAME OR
SOURCES OF IGNITION. DO NOT STORE IN HIGH TEMP STORAGE.IN CASE OF
FIRE, REMOVE CLSD CNTNRS FROM AREAS EXPOSED TO FIRE.
Other Precautions:EMPTY CONTAINERS USUALLY STILL HOLD RESIDUES OF
MATERIAL AND VAPORS. THESE MUST BE CONSIDERED HAZARDOUS AND
DISPOSED OF IN ACCORDANCE WITH PROPER HANDLING PROCEDURES
PRESCRIBED FOR HAZARDOUS CHEMICALS .

Exposure Controls

Respiratory Protection:ALL RESPIRATORS MUST BE NIOSH/MSHA APPROVED. USE
OF APPRVD RESPS REC WHEN USING SOLV BASED COATINGS. WHEN LEVEL OF
SOLV VAPS IS NOT KNOWN OR EXCEEDS LEVEL AT WHICH REGULAR RESPS
EFTIVE, USE RESPS SUCH AS TC-19C IS HIGHLY RECOMMENDED.
Ventilation:BE SURE TO PROVIDE ADEQ VENT IN ALL WORKING AREAS AT ALL
TIMES. SERIOUS HLTH PROBLEMS COULD RSLT FROM RPTD/PRLNGD EXPOS.
Protective Gloves:NEOPRENE OR BUNA N GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:STANDARD HYGIENIC PRACTICES MUST BE OBSERVED
WHEN HANDLING ALL CHEMICALS.
Supplemental Safety and Health
FIRE FIGHT PROC:EXPOSED TO FIRE. EXPLO HAZ:PLACE WHEN NOT IN USE.

Chemical Properties

HCC:N1
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:1.2
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT SOLUBLE
Appearance and Odor:RED OXIDE PAINT-PAINT THINNER ODOR

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALIS. LONG TERM CONTACT WITH WATER.
Stability Condition to Avoid:AVOID OPEN FLAMES, WELDING ARCS OR OTHER
HIGH TEMPERATURE SOURCES WHICH INDUCE THERMAL DECOMPOSITION AND
FIRE.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CO
AND/OR CO*2.

Disposal

Waste Disposal Methods:DISPOSE OF ALL WASTES, INCLUDING ABSORBENTS USED
TO CLEAN UP SPILLS INTO 55-GAL METAL CONTAINERS AND DISPOSE IN
APPROVED DUMPSITE IN ACCORDANCE WITH PRESCRIBED FEDERAL, STATE, AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.